Making it Practical

It is very easy to create a roulette computer that works well at home in front of your TV or your own wheel. After all, you can control variables such as how often the wheel spins. But the real casino environment is very different – sometimes you need to wait 5 minutes between spins, some dealers spin the ball far too slow to target a specific ball speed (as you need with basic computers), you need to evade the casino’s wireless scanners and much more. Below are the main practicality issues for roulette computer play.

Time of Application

One of the most frustrating issues you will face is the time delay between spins. Typically you will need 30-60 spins per direction before the computer has learned enough about the wheel before you can start profiting. With most computers this takes 1-3 hours or even longer when the casino is very busy. Below are comparisons between every other roulette computer and my advanced computers:

Every other computer My advanced computers
How long it takes for the computer to fully tune (when you can start betting). Each and every time you play, you need to tune the computer over about 100 spins (roughly 50 spins per direction). This is of course assuming the computer is actually effective. Throughout the 100 spins, the ball’s deceleration would have changed considerably. On some days it may remain consistent, but on most days the changes are significant and you will not know why on some days you win, and some days you lose.On the next day, you must repeat it all again because the conditions are too different.You can only possibly profit if it is an easily beaten wheel, and some factor doesn’t affect ball deceleration rates (such as air pressure changes, grit on ball track, sweat from dealer’s fingers etc).

Beware of vendors that claim their device is set up and ready for profitable play after a single spin as this is impossible.

The first day you take your initial ball sample and the computer automatically tunes as you play. The computer automatically adjusts for ball deceleration rate changes to ensure optimal accuracy. Accuracy gradually improves, but in as few as 15 spins on many wheels, you will be able to begin profiting. After about 100 spins (roughly 50 spins per direction), maximum accuracy is achieved and you can confidently bet on almost any wheel.On following days, you do NOT need to repeat the procedure. You can resume betting immediately, because the computer continues to learn the ball deceleration. This means following days are much quicker and easier.

Getting Predictions in Time

This was also discussed in the Getting Early Predictions section. Whatever you can imagine can be done with manual clocking computers is done by my Uber version computer. It is the only roulette computer available anywhere to have these capabilities. Some of them were demonstrated in a public demonstration (see videos page for the recording).

Avoiding Detection

Full details of how my roulette computers avoid detection is only explained to actual players. But basic details are in the Avoiding Detection section. Even if a computer works at home in front of your TV, it is useless if you are detected in a casino so remaining undetected is essential.

If you’ve read and understood all the pages about how to make a roulette computer, see the roulette computer comparisons page to understand what makes each roulette computer different